DeWalt DCS520 Traducido De Las Instrucciones Originales página 12

English
Fig. D
13
6. Use the hex wrench to turn the blade clamping
screw 24 counter-clockwise to remove.
7. Remove the outer flange
the new blade on the inner flange
8. Replace the outer flange
screw . Turn the screw clockwise by hand.
24
nOTE: The direction of rotation of the saw blade and the
rotation of the track saw MUST be the same.
9. Tighten the blade clamping screw firmly using the
hex wrench.
10. Release and turn the spindle lock lever
clockwise until it stops.
11. Move the track saw back to top position.
12. Push the plunge trigger 1
of blade change mode.
10
12
25 and used blade 10 . Place
26 .
25 and blade clamping
13 counter-
forward, to take the saw out
Fig. E
26
21
25
24
10
22
21
5/64"-1/8"
5/64"-1/8"
(2–3 mm)
(2–3 mm)
Adjusting the Riving Knife (Fig. A1, D, E)
For the correct adjustment of the riving knife
to Figure E. Adjust the clearance of the riving knife after
changing the saw blade or whenever necessary.
1. Follow Changing the Saw Blade steps 1–5.
2. Loosen the riving knife adjustment screw
wrench and set the riving knife as shown in Figure E.
3. Tighten the riving knife adjustment screw
4. Turn the spindle lock lever
it stops.
5. Move the track saw back to top position.
6. Push the plunge trigger
1
of blade change mode.
Depth of Cut Adjustment (Fig. F)
The cutting depth can be set at 0–2.3" (0–59 mm) without
guide rail attached; with the guide rail attached: 0–2.2"
(0–55 mm).
1. Loosen the depth adjustment knob
pointer to obtain the correct depth of cut.
2. Tighten the depth adjustment knob
23
, refer
21
with a hex
22
.
22
counter-clockwise until
13
forward, to take the saw out
and move the
8
8 .