Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SPEAKERS
WATER BOTTLE HOLDER
5.1 AT
SHOWN
GRIP PULSE HANDRAILS
CONSOLE MAST
MOTOR COVER
MAIN FRAME BOOT (5.1AT shown)
CAUTION AVERTISSEMENT PRECAUCIÓN
KEEP HANDS AND FEET
GARDER LES MAINS ET LES
MANTENGA LAS MANOS Y
AWAY FROM THIS AREA.
PIEDS LOIN DE CETTE REGION.
LOS PIES LEJOS DE ESTA
HIGH-PRESSURE
LES AMORTISSEURS À HAUTE
AREA. IMPACTOS DE ALTA
SHOCKS COULD CAUSE
PRESSION PEUVENT CAUSER
PRESIÓN PUEDEN CAUSAR
BODILY INJURY.
DES BLESSURES.
DAÑO CORPORAL.
1
2
TRANSPORT WHEEL
WHEEL LOCK
1
2
ABOVE FOOT LATCH
8
31AT_51AT_OM_Rev1_4.indd 8-9
TOOLS INCLUDED:
F 8 mm T-Wrench
USB PORT AND AUDIO IN JACK
F 5 mm T-Wrench
F 5 mm L-Wrench
CONSOLE
F Screwdriver
SAFETY KEY PLACEMENT
PARTS INCLUDED:
F 1 Console Assembly
ON/OFF SWITCH
F 1 Handlebar Assembly
F 2 Console Mast Caps
CIRCUIT BREAKER
F 2 Console Masts
F 2 Main Frame Boots
POWER CORD
F 1 Hardware Kit
F 1 Safety Key
FOOT LOCK LATCH (UNDERNEATH DECK)
F 1 Power Cord
F 1 Audio Adapter Cable
RUNNING BELT / RUNNING DECK
SIDE RAIL
ROLLER END CAP
there are any missing parts,
REAR ROLLER
TENSION/ADJUSTMENT BOLTS
Support. Contact information
is located on the back panel
CAUTION AVERTISSEMENT PRECAUCIÓN
KEEP HANDS AND FEET
GARDER LES MAINS ET LES
MANTENGA LAS MANOS Y LOS
AWAY FROM THIS AREA.
PIEDS LOIN DE CETTE REGION.
PIES LEJOS DE ESTA AREA.
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Once the banding straps have been removed, do not transport this unit unless it is
fully assembled. Unpack and assemble the unit where it will be used. Never grab hold of
any portion of the incline frame and attempt to lift or move the treadmill. Lift the treadmill
from the roller end caps area while a second person removes the parts packed under
the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NEED HELP?
If you have questions or if
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
contact Customer Tech
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.
of this manual.
9
8/29/11 8:59 AM
Publicidad
Tabla de contenido
