AFG 3.1AT Manual Del Propietário página 6

5.1AT ASSEMBLY STEP 1
5.1 AT
BOLT (A) SPRING WASHER (B)
ONLY 20 mm 8.2 mm
Qty: 6 Qty: 6
SCREWS (D)
SCREWS (L)
MAIN FRAME BOOT
MAIN FRAME
10
31AT_51AT_OM_Rev1_4.indd 10-11
HARDWARE FOR STEP 1 :
ARC WASHER (C) SCREW (D) SCREW (L)
8.2 mm 12 mm 20 mm
Qty: 6 Qty: 8 Qty: 2
* This step is for 5.1AT models only. For 3.1AT models,
proceed to page 12.
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
B Open HARDWARE FOR STEP 1.
C Place MAIN FRAME BOOTS over MAIN FRAME as
shown.
Attach MAIN FRAME BOOTS to MAIN FRAME
D
using 8 SCREWS (D) from above and 2 SCREWS
(L) from the front.
5.1AT ASSEMBLY STEP 1 CONTINUED
RIGHT CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
Pull LEAD WIRE through RIGHT CONSOLE MAST.
E
After pulling the LEAD WIRE through the mast, the
top of the CONSOLE CABLE should be located at
the top of the mast. Detach and discard LEAD WIRE.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
F Place RIGHT CONSOLE MAST over MAIN FRAME
BRACKET.
G Attach CONSOLE MAST to MAIN FRAME
BRACKET using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC WASHERS (C).
NOTE: Do not tighten bolts until step 3 is complete.
H Repeat steps F–G on other side.
8/29/11 8:59 AM
5.1 AT
ONLY
11