AFG 3.1AT Manual Del Propietário página 9

Ocultar thumbs Ver también para 3.1AT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY STEP 5
HARDWARE FOR STEP 5 :
ALL
BOLT (H)
SPRING WASHER (I)
MODELS
12 mm
6.2 mm
Qty: 4
Qty: 4
CONSOLE CABLES
HANDLEBARS
CENTER BAR
ARC WASHERS (J)
SPRING WASHERS (I)
BOLTS (H)
CONSOLE CABLES
16
31AT_51AT_OM_Rev1_4.indd 16-17
A
Open HARDWARE FOR STEP 5.
B
Connect the CONSOLE CABLES, discard the
twist tie and slide the CONSOLE CABLES into the
ARC WASHER (J)
6.2 mm
CENTER BAR.
Qty: 4
C
Attach HANDLEBARS to CENTER BAR using 4
BOLTS (H), 4 SPRING WASHERS (I) and 4 ARC
WASHERS (J).
NOTE: Do not tighten bolts until step 6 is complete.
Do not pinch wires while assembling the handlebars.
ASSEMBLY STEP 6
HARDWARE FOR STEP 6 :
BOLT (K)
SPRING WASHER (B)
FLAT WASHER (F)
15 mm
8.2 mm
8.2 mm
Qty: 6
Qty: 6
Qty: 6
CONSOLE
CONSOLE CABLES
HANDLEBARS
BOLTS (K)
SPRING WASHERS (B)
FLAT WASHERS (F)
A
Open HARDWARE FOR STEP 6.
B
Attach CONSOLE CABLES from HANDLEBARS
to CONSOLE CABLES from CONSOLE. Gently
tuck excess cable into CONSOLE before sliding the
HANDLEBARS onto CONSOLE.
C
Attach HANDLEBARS to CONSOLE using 6
BOLTS (K), 6 SPRING WASHERS (B) and 6 FLAT
WASHERS (F).
D
Completely tighten all bolts from step 5.
NOTE: Do not pinch wires while attaching
the handlebars.
IMPORTANT
This treadmill has a pre-waxed belt and
should never be lubricated. Waxing
the belt can cause damage that is not
covered by the warranty.
YOU ARE FINISHED!
8/29/11 8:59 AM
ALL
MODELS
17

Publicidad

Tabla de contenido
loading

Productos relacionados para AFG 3.1AT

Este manual también es adecuado para:

5.1at

Tabla de contenido