AFG 3.1AT Manual Del Propietário página 7

3.1AT ASSEMBLY STEP 1
HARDWARE FOR STEP 1 :
3.1 AT
BOLT (A) SPRING WASHER (B)
20 mm 8.2 mm
ONLY
Qty: 6 Qty: 6
RIGHT CONSOLE MAST
MAIN FRAME BOOT
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
12
31AT_51AT_OM_Rev1_4.indd 12-13
* This step is for 3.1AT models only.
A Cut the yellow banding straps and lift the running
ARC WASHER (C)
deck upward to remove all contents from underneath
8.2 mm
the running deck.
Qty: 6
B Open HARDWARE FOR STEP 1.
C Slide MAIN FRAME BOOT up CONSOLE MAST.
Pull LEAD WIRE through RIGHT CONSOLE MAST.
After pulling the LEAD WIRE through the mast, the
top of the CONSOLE CABLE should be located at
the top of the mast. Detach and discard LEAD WIRE.
LEAD WIRE
NOTE: Do not pinch console cable when placing
CONSOLE CABLE
the mast onto the main frame bracket.
D Place RIGHT CONSOLE MAST over MAIN FRAME
BRACKET.
E Attach CONSOLE MAST to MAIN FRAME
BRACKET using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC WASHERS (C).
NOTE: Do not tighten bolts until step 3 is complete.
F Repeat steps D–E to attach LEFT CONSOLE MAST.
ASSEMBLY STEP 2
HARDWARE FOR STEP 2 :
FLAT WASHER (F)
BOLT (E) SPRING WASHER (B)
20 mm 8.2 mm 8.2 mm
Qty: 6 Qty: 6 Qty: 6
BOLTS (E)
SPRING WASHERS (B)
FLAT WASHERS (F)
CONSOLE MAST CAP
CONSOLE (upside down)
Open HARDWARE FOR STEP 2.
A
With the CONSOLE upside down, attach the
B
CONSOLE MAST CAPS to the CONSOLE
using 6 BOLTS (E), 6 SPRING WASHERS
(B) and 6 FLAT WASHERS (F).
8/29/11 8:59 AM
ALL
MODELS
13