Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
reSiStance meaSUrementS
ert
1. Insert RED test lead into VΩ jack
COM
into COM jack
highest Ω setting (2MΩ).
2. Remove power from circuit.
3. Measure resistance by connecting test leads to circuit and
rotating the function selector switch
lower Ω settings to obtain higher resolution measurements.
nto
ate
note: When in a Resistance setting and the test leads are open
00mA).
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
Do not attempt to measure resistance on a live circuit.
continUity
1. Insert RED test lead into VΩ jack
jack
2. Remove power from circuit.
cuit at
using
3. Test for continuity by connecting conductor or circuit with test
to-
leads. If resistance is measured less than 100Ω, an audible
range.
signal will sound and display will show a resistance value
indicating continuity. If circuit is open, display will show "ol".
be
r
Do not attempt to measure continuity on a live circuit.
MM300-1390109ART.indd 9
operatinG inStrUctionS
, and rotate function selector switch
4
Black lead
Red lead
, and rotate function selector switch
4
Black lead
Red lead
Dwg Name: MM300-1390109ART
Dwg No: 1390109
ECO No: 20617
Pkg Dwg Ref: 1290186
Color Reference: N/A
, and BLACK test lead
5
to successively
2
and BLACK test lead into COM
5
to the
2
Rev: E
to the
2
setting.
9
9/21/2015 2:48:05 PM
Publicidad
