EHEIM LOOP pro 26000 Manual De Instrucciones página 14

English
3. On the left side, fasten the UVC clarifier with the union nut ①.
4. On the right side, fasten the UVC clarifier with the plug ②.
Use the spanner included in the scope of delivery for installing the union nut and the plug.
Fitting the hose connecting piece (⌦D)
1. Slide the union nut ③ onto the hose connecting piece ②.
2. Insert the seal ① into the union nut.
3. Screw the hose connecting piece onto the UVC clarifier with the union nut.
Inserting the filter (⌦E)
1. Check the correct fit of the seal ⑤ in the filter insert ①.
2. Check the correct fit of the seal ⑥ in the prefilter tub ③.
3. Fill the two filter baskets ② with one bag of EHEIM FILTERBIO ⑦ each and rinse them out with
running water.
Make sure that the filter baskets are not filled to overflowing!
4. Insert the filter in the filter housing in the following order:
① Filter insert with filter foams
② Filter baskets with EHEIM FILTERBIO ⑦
③ Prefilter tub
④ Blue prefilter mat
5. Place the filter container cover onto the filter container and close it using all six fastening clips.
Installing the pump connection (⌦H)
1. Screw the hose connecting piece into the pump.
2. Use the spiral hose to connect the hose connecting piece of the pump with the hose connecting
piece of the UVC clarifier.
We recommend fastening the hoses with hose clamps.
Connecting the outlet pipe (optional)
Optionally, you can connect the extension pipe (Ø approx. 75 mm) to the outlet pipe.
Operation
DANGER! Electric shock!
▶ When the UVC clarifier is fitted, the device's safety distance from the water must be at least 2 m.
DANGER!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety,
commissioning and operation!
1. Place the filter on the pond bank (⌦H).
14