STAMOS S-MMA-100 MINI Manual De Instrucciones página 20

1.
Welding current adjustment knob
2. Power light
Thermal overload indicator light - When the device overheats, this light will turn on
and the device will turn off. Do not try to restart welding by leaving the machine with
3.
the fans running. The indicator will automatically turn off when the device cools
down. Pay attention to the rated duty cycle.
4.
Welding current display.
5. Welding cable socket (positive pole)
6. Workpiece lead socket (negative pole)
Rear view:
1. Main ON / OFF switch
2. Power cord
7. Connecting the wires
CAUTION! The electrical installation to which the machine would be connected should be equipped
with an overcurrent fuse.
If an extension cord is used, its cross-section should be at least the same as that of the power cord.
CAUTION! Connecting the cables to the device must be done with the power supply disconnected
and the device turned off.