Publicidad
Idiomas disponibles
Idiomas disponibles
Page 5
8
Fig. A: Assembly tools
Fig. B: Stand/Wall mounting is also
possible
Page 2
Fig. A:
Scope of delivery single headlamp
Page 3
Unscrew headlamp holder 1 (theft
protection) and detach from housing
2 .
Unlatch and pull off adapter for
illuminant 3 including cap 11.
Make sure the illuminant is securely
fitted, then push on adaptor 3 in
accordance with the required
position of the lead exit and secure.
Assemble housing and holder.
Mark mounting location and drill.
Treat drilled metal parts with rust
preventive.
Page 4
Electrical equipment
Abb. A: Single headlamp
Abb. B: Headlamp set
The auxiliary lamps must be
mounted symmetrically and
vibration-free on an even and stable
base without affecting the engine
cooling. The headlamps must not
Fig. B:
Scope of delivery headlamp set
Fig. C:
Accessories for dowel mounting.
Hand-screw, align and tighten
headlamp with compensation plate
6 and washer.
Re-assemble housing 2 and holder
1 .
(Alternatively: dowel mounting,
page 2, Fig. C is possible.)
Attach ballast 7 with bracket 8
near the headlamp (max. length of
cable 45 cm) in a location protected
against splash water and from sight.
Make sure the supply cable between
headlamp and ballast is not twisted
more than 90° and not bent with a
radius of less than 20 mm.
Cable colours:
= brown
= blue
A
C
= red
= yellow/grey
B
D
project over the sides of the vehicle
or 4 m overall height.
For dowel mounting, first drill 1 hole
only, tighten hand-tight, align, then
drill second hole and tighten
headlamp down.
Place sealing ring 9 onto plug 10 ,
connect plug 10 to illuminant,
secure, and put on cover cap 11 .
Only use the special cable set
supplied for electrical connection.
First, disconnect the earth cable from
the battery and then wire up in
accordance with the wiring diagram
(see Fig. 4).
Install relay using connecting
terminals in a location protected
against splash water.
Publicidad
