Suzuki 57100-1081 Serie Instrucciones De Instalación página 4

4 /17
Installation of Grip Heater (R)
Installation
1. Loosen the bolt and remove
the handlebar balancer.
2. Slide the boot, loosen the lock-
nut of the throttle cable, and
tighten fully the adjuster. Then,
loosen the throttle cable.
3. Remove screws from the switch
box. First disconnect throttle
cable No.2, then No.1 with
care, and pull out the throttle
grip.
NOTE:
Removed
reused.
Do not remove the throttle
cable No.1 and No.2 forcibly
by using pliers or other tools.
The throttle cable may bend,
and it may cause the improper
return of the throttle.
GENUINE SUZUKI ACCESSORIES
throttle grip will not be
NOTICE
Handlebar balancer
Boot
Lock-nut
Throttle cable No.1
Switch box
Throttle cable No.2
Bolt
Adjuster
Throttle grip