Publicidad
Idiomas disponibles
Idiomas disponibles
After Operation
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 12
1. Battery pack cavity
2. Battery pack venting areas 5. LED indicators (current
3. Battery pack terminals
2.
Line up the cavity in the battery pack
with the tongue on the charger.
3.
Slide the charger into the battery pack until it is
fully seated
(Figure
4.
To remove the battery pack, slide the charger
backward out of the battery pack.
5.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
Indicates
light
No battery pack inserted
Off
Green
Battery pack is charging
blinking
11).
4. Battery-charge-indicator
button
charge)
6. Handle
(Figure
12).
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
*Refer to
Troubleshooting (page 20)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
Cleaning the Machine
Service Interval: After each use
Cleaning under the Machine
Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1.
Shut off the machine and remove the battery
pack and the safety key.
2.
Lower the machine to its lowest cutting-height
setting.
3.
Set the machine in the vertical-stow position;
refer to
Storing the Machine in the Vertical-Stow
Position (page
4.
Using a brush or broom, clean any debris away
g347460
from the underside of the machine.
Important:
machine; water may damage electrical
components.
5.
Clean the grass box.
12)
16
for more
19).
17).
Do not use water to clean the
Publicidad
