Rupes RX153A Traduccion Del Manual De Instrucciones Originales página 9

LED blinking indication
The LED shows the type of protection with different code of blinking:
TOOL PROTECTION
Blocked rotor
Overcurrent
Temperature cut-out
Current spike
DUST EXTRACTION
WARNING: Dust can be hazardous to health. Always work with a dust extractor. Always read
applicable nation regulations before extracting hazardous dust.
The sander does not have the self-generated dust extraction. Connect a RUPES dust extraction system at the
extractor connector (6).
NOISE EMISSION VALUES
Noise emission values determined according to EN 62841-2-4:
SOUND PRESSURE LEVEL
SOUND POWER LEVEL
UNCERTAINTY (K)
Use ear protection!
VIBRATION EMISSION VALUES
Vibration total values a h (triax vector sum) and uncertainty K determined according to EN 62841-2-4:
3 AXIS VIBRATION LEVEL (a h )
UNCERTAINTY (K)
Displayed emission values are comparative and are to be employed for a provisional assessment of the operator's
risk exposure during the work period. Appropriate evaluation of work period must also include tool's idle and stop
periods. These emission values represent the tool's main applications. If the tool is used for other applications,
with other accessories, or if it does not undergo regular maintenance, emission values can significantly increase
during operations.
CAUTION: The indicated measurements refer to new power tools. Daily usage causes the noise and
vibration values to change.
MAINTENANCE AND SERVICING
WARNING: All maintenance operation must be performed with the power disconnected.
CLEANING
At the end of each work session, or when required, remove any dust from the body of the tool using a soft cloth,
paying particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by the user.
REPAIRS
Maintenance and cleaning of the inner parts like ball bearings, gears etc. or others, must be carried out only by
an authorized customer service workshop.
BLINKING
Repeated blinking
Blink-Pause-Blink
2 Blinks-Pause- 2 Blinks
3 Blinks-Pause- 3 Blinks
SOLUTION
Switch-off the tool immediately and eliminate the fault
before restart the tool.
Restart the tools and reduce the load to the sander; if
the protection is repeated, stop the tool for a short
time.
Restart the tools and reduce the load to the sander; if
the protection is repeated, stop the tool for a short
time.
Restart the tools; if the protection is repeated, stop the
tool for a short time.
RX153A/RX253A - RX156A/RX256A
dB(A)
dB(A)
dB
RX153A/RX253A
m/s 2.5
2
m/s 1.2
2
72.5
82.5
3.0
RX156A/RX256A
3.0
1.2
9