Safety Standards - Gossen MetraWatt METRACLIP 41 Manual De Instrucciones

Unclamp the clamp meter from the conductor, turn it off
using the On - Off switch.
Loosen the captive screw which secures the battery
cover. Lift the cover through 30° and pull it clea r of the
body as shown in Fig 1. Replace the battery and re-fit
the battery cover and fasten the screw .
Fit only Type 9 V PP3 Alkaline (MN 1604).

5. SAFETY STANDARDS

EN 61010-1:2001
EN 61010-2-032:2002
EN 61010-031:2002
300V Cat III Pollution Degree 2
EMC Standards
EN 61326-2-2:2006
ROHS and WEEE compliant
This product is designed to be safe under the following
conditions:
- indoor use
- altitude up to 2000m
- temperature 0° C to +50° C
- maximum relative humidity 80% for
temperatures up to 31° C decreasing linearly
to 40% relative humidity at 50° C.
Use of the clamp-on-meter
conductors is limited to 300V AC
frequencies below 1kHz.
Safety in its use is the responsibility of the operator
who must be a suitably qualified or authorised person.
Ensure that your fingers are behind the protective
barrier see FIG 1 when using the clamp meter. Always
inspect the clamp-on-meter for damage before use.
To avoid electric shock, keep the clamp-on-meter clean
and free of surface contamination.
Use Isopropyl alcohol to clean the clamp-on-meter.
on uninsulated
or d.c. and
RMS
7