ST R72 Li 48 V1 Manual De Instrucciones página 255

a. Pre-set for cutting and collecting grass in the
grass catcher
Hook the grass catcher bag (fig. 9.A) by
inserting the two attachments (fig. 9.C) into
the slots (fig. 9.F) in the two supports (fig.
9.B).
Make sure that the grass catcher frame (fig.
9.D) hooks on to the stop pawl (fig. 9.E).
b. Pre-set for cutting and rear unloading of grass
to ground
If you want to work without the grass
catcher, a rear unload protection kit is
available on request (optional, par.16.3)
which must be mounted on the rear plate
as indicated in the pertinent instructions.
c. Pre-set for cutting and chopping grass
If you decide to mow grass, mulch it
and leave it on the lawn, a "mulching"
kit is available upon request (chap.
16.1). This has to be attached to the rear
plate as indicated in the instructions.
7.2 SAFETY CHECKS
Run the following safety checks and
ensure that the results correspond
to those outlined in the tables.
SAFETY INSTRUCTION
Always perform safety checks before use.
Status
operator seated.
Drive pedal in neutral position
(pedal released).
Emergency button deactivated.
Machine on or in operation.
operator seated.
Drive pedal in forward or
reverse position.
7.2.1 General safety check
Batteries.
Pushbutton panel
controls and commands
Rear unload guard,
grass catcher.
Electrical cables
Operate the machine
forwards/reverse and
release the drive pedal.
Safety devices
7.2.2 Control of safety devices
The safety devices work in two ways:
A. To prevent the machine from starting if all
B. To stop the machine if even just one of
Action
Fully insert the key
The operator stands up from the seat. All services are deactivated. The
Try to
start the machine.
EN - 16
Object
the safety requirements have not been met;
the safety requirements is lacking.
the machine is ready
to be turned ON.
icon in fig. 7.E icon flashes and
the icon in fig. 7.P is illuminated.
The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1, 2, 4 and
5 flash.
Result
No damage to
casing and cover.
Good condition.
No damage.
Good condition. No
damage. Properly
installed.
All insulation intact.
No mechanical damage.
The machine slows
down and stops.
Proceed as indicated
in par. 7.2.2
Result