Makita 4190D Manual De Instrucciones página 6

Cortadora inalámbrica
Ocultar thumbs Ver también para 4190D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing or removing battery cartridge
003507
Always switch off the tool before insertion or
removal of the battery cartridge.
To remove the battery cartridge, pull out the set
plate on the tool and grasp both sides of the
cartridge while withdrawing it from the tool.
To insert the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Snap the set plate back into
place. Be sure to close the set plate fully before
using the tool to prevent the battery cartridge from
accidentally falling out of the tool.
Do not use force when inserting the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Adjusting the depth of cut
3
003509
Loosen the bolt (A) on the depth guide with the hex
wrench and move the base up or down. At the desired
depth of cut, secure the base by tightening the bolt (A).
Bevel cutting
1
2
003514
1. Set plate
2. Battery
1
cartridge
2
1. Depth guide
2. Bolt (A)
1
3. Hex wrench
2
1. Bevel scale
plate
2. Bolt (B)
3. Bolt (A)
3
Loosen the bolt (A) on the depth guide and the bolt (B)
on the bevel scale plate with the hex wrench. Set for the
desired angle (0° - 45° ) by tilting accordingly, then
tighten the bolts (A) and (B) securely.
CAUTION:
After adjusting depth of cut and bevel cutting angle,
be sure to tighten the bolts (A) and (B) securely.
Sighting
1
A
003519
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
NOTE:
When making bevel cuts, view the cutting line on
the workpiece through the window in the blade
case in order to cut more accurately. If you have
difficulty seeing it because of the water tank, adjust
the position of the tank by tilting it backward
slightly.
Switch action
1
2
003522
CAUTION:
Before inserting the battery cartridge into the tool,
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
To start the tool, slide the lock-off lever in the direction of
the arrow and pull the switch trigger. Release the switch
trigger to stop.
6
1. Blade case
2. Base
B
2
1. Lock-off lever
2. Switch trigger

Publicidad

Tabla de contenido
loading

Tabla de contenido