Franke FRSM 302 C TD BK Manual De Instalación Y Servicio página 9

CONTROL PANEL
FRSM 302 C T BK AUS
2 9 8
3
2 3
1. Power ON
2. Cooking area
3. Power display
4. Less/More
5. Timer
CONTROLS
The cooking hob is controlled by an electronic microprocessor. The
control software detects both controls and the presence of any abnormal
operating conditions, such as:
• the spilling of liquids or presence of other objects on the control
panel;
• presence of condensate inside the hob.
In the event of any of above conditions, the system sets to safety
alarm status: the powered-on plates are immediately turned o and an
error code is displayed. Standard operation is resumed once the cause of
the alarm condition has been removed. If operation is not restored,
it may be necessary to disconnect the mains power and reconnect it.
DAILY USE
TOUCH CONTROL HEATING ELEMENTS
TOUCH CONTROL
weak
1
2-3 gentle
4 slow
5-6 medium
7-8 strong
9 very strong
SWITCHING ON THE DEVICE
1. Press the key (1) to activate the control: the adjustment-level
indicators (3) show "0" and a power-on LED appears under the
1 key.
2. Perform the next operation within 10 seconds, otherwise the
device will switch o automatically.
1 6 5
10
4 4
HEAT INTENSITY
FRSM 302 C TD BK
2 3
2 3
6. Display timer
7. Double-circuit LED
8. Power ON LED
9. Decimal point
10. Timer decimal point
TOUCH KEYS
All operations can be performed using the touch keys (capacitive
sensors) located on the front face of the control panel; Each key
corresponds to as display.
Each activity is con rmed by a beep.
ADJUSTING POWER AND THE TIMER BY MEANS OF THE
KEYS
Use the and keys (4) to adjust the setting of the plates and the
required time on timer/minute counter (6). The
(4) are common to both functions. Accordingly, to regulate the power of
the hob, rst select the zone with key (2), then adjust the relative power
level using the and
with key (5) and proceed to set the duration, likewise using the
key (4).
SWITCHING ON THE COOKING AREA
Once the device has been activated, switch on the cooking area (within
10 seconds) as follows:
1. Press one of the keys (2) to select the cooking area required.
2. The related display is brighter.
3. Use the and
Press and hold down these keys to increase or decrease the setting.
– 9 –
9 8 1 6 10 5
4 7 4
and
keys (4); this done, select the timer function
keys (4) to adjust the heat level (from 1 to 9).
EN
AND
controls
or