Descargar Imprimir esta página

Makita DLM460 Manual De Instrucciones página 10

Ocultar thumbs Ver también para DLM460:

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: If the lock key is not inserted, the power lamp
blinks in green when you pull the switch lever.
5.
Release the switch button as soon as the motor
starts running. The mower will continue to run until you
release the switch lever.
6.
Release the switch lever to stop the motor.
Adjusting the mowing height
WARNING:
Never put your hand or leg under
the mower body when adjusting the mowing
height.
WARNING:
Always make sure that the lever
fits in the groove properly before operation.
The mowing height can be adjusted in the range of
between 20 mm (13/16") and 75 mm (2-15/16").
Remove the lock key, and then pull the mowing height
adjusting lever outward of the mower body and move it
to your desired mowing height.
► 1. Mowing height adjusting lever
Hold the front grip with one hand, and then move the
mowing height adjusting lever with the other hand.
► 1. Mowing height adjusting lever 2. Front grip
NOTE: The mowing height figures should be used
just as a guideline. Depending on the conditions of
the lawn or the ground, the actual lawn height may
become slightly different from the set height.
NOTE: Try a test mowing of grass in a less conspicu-
ous place to get your desired height.
1
1
2
Adjusting the handle height
CAUTION:
Before removing the bolts, hold
the upper handle firmly. Otherwise, the handle may
fall and cause an injury.
The handle height can be adjusted in three levels.
1.
Loosen the thumb nuts of the lower handle, and
then remove the bolts, washer, and thumb nuts.
1
2
► 1. Thumb nut 2. Washer 3. Bolt
2.
Adjust the handle height.
3.
Insert the bolts from inside, then attach washers
from outside, and then tighten the thumb nuts.
Using mulching attachment
The mulching attachment allows you to return the cut
grass to the ground without gathering the cut grass in
the grass basket. When you operate the machine with
the mulching attachment, be sure to remove the grass
basket.
NOTICE:
When using the machine with the
mulching plug, make sure that the total length of
grass after cutting is 30 mm or more, and the cut
length is 15 mm or less.
10 ENGLISH
3
2
1

Publicidad

loading