IKEA FORNEBY Serie Manual De Instrucciones página 91

ENGLISH
Step 5 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
Step 6 Pull the door trim to the front to re‐
move it.
Step 7 Hold the door glass panels by their
top edge and carefully pull them out
one by one. Start from the top pan‐
el. Make sure the glass slides out of
the supports completely.
Step 8 Clean the glass panels with water and soap. Dry the glass panels carefully. Do
Step 9 After cleaning, install the glass panels, the door trim and the oven door, close
If the door is installed correctly, you will hear a click when closing the latches.
Make sure that you put the glass panels (A
and B) back in the correct sequence. Check
for the symbol / printing on the side of the
glass panel, each of the glass panels looks
different to make the disassembly and as‐
sembly easier.
The screen-printing zone must face the in‐
ner side of the door. Make sure that after
the installation the surface of the glass pan‐
el frame on the screen-printing zones is not
rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the middle panel
of glass in the seats correctly.
not clean the glass panels in the dishwasher.
the latches on the both hinges.
2
B
A B
91
1
A
B