Maintenance And Servicing; Cleaning The Jet Plate; Replacement Parts - Franke AQUA757 Instrucciones De Montaje Y Uso

7.8 Slide the shower pipe (b) into the shower head as far as possible.
☞
Slide the shower pipe straight into the shower head.
7.9 Adapt the shower pipe.
7.10 Rotate the shower pipe as close to the fitting as possible.
7.11 Measure the distance (X) from the underside of the flanged edge to the upper edge
of the fitting.
7.12 Pull the shower pipe from the shower head.
Caution!
Do NOT cut off the flanged edge (c) from the shower pipe.
7.13 Shorten the shower pipe by the amount X and de-burr.
7.14 Slide the shower pipe into the shower head and fasten to the fitting.
7.15 Fit the flow-rate regulator (e) and the seal (d) into the fitting.
☞
Important!
Ensure correct installation position of the flow rate controller.
8.

Maintenance and Servicing

Depending on the quality of the water, the local conditions and the rules and regula-
tions applicable on site, the fitting must be maintained and serviced at regular
intervals.
Properly use suitable cleaning agents that are not harmful to the fittings and rinse
with water after use. High-pressure cleaners must not be used for cleaning.
9.

Cleaning the Jet Plate

9.1 Loosen the screw with a hollow hexagon wrench.
9.2 Using a screwdriver, carefully lift out the jet plate.
9.3 Clean the jet-plate.
9.4 Reassemble in the reverse order.

10. Replacement Parts

1 Spare parts kit, shower head . . . . . 2000104849
2 Flow rate regulator
0.20 l/s (red) . . . . . . . . . . . . . . . 2000104783
0.15 l/s (orange) . . . . . . . . . . . . 2000104782
5