Setting Cleaning Switch-Off; Maintenance And Servicing - Franke AQCT0031 Instrucciones De Montaje Y Uso

18. Setting Cleaning Switch-off

Cleaning switch-off can be set either with the remote control (not included, see
Accessories Chapter
Cleaning switch-off on the fitting
18.1 Allow your hand to approach the sensor at a distance of about 10 cm for 3 seconds.
18.2 Move your hand away from the sensor detection range between the 3rd and 5th
flash of the LED.
• LED does not flash.
18.3 After 3 to 10 seconds, allow your hand to approach the sensor again at a distance of
approx. 10 cm.
18.4 After the third LED flash, move your hand back out of the sensor detection range.
• The fitting is switched off for 3 minutes.
• The LED flashes with a 10 second cycle.
☞
When you allow your hand to approach the sensor at a distance of about 10 cm for
at least 3 seconds, the fitting is reactivated before the end of 3 minutes.

19. Maintenance and Servicing

Depending on the quality of the water, the local conditions and the rules and regula-
tions applicable on site, the fitting must be maintained and serviced at regular
intervals.
Perform maintenance on the following components:
• Shower head (see
• Filters (see
Properly use suitable cleaning agents that are not harmful to the fittings and rinse
with water after use. High-pressure cleaners must not be used for cleaning.
Removing the shower panel
Some maintenance work requires that the shower panel must be removed.
Caution!
!
Never let the shower panel hang by the connecting hoses.
25) or it can be activated directly on the fitting.
Chapter 21.)
Chapter 22.)
- 10 -