Publicidad
Idiomas disponibles
Idiomas disponibles
The gas must only be loaded into the appliance by authorised
professional personnel. This task is dangerous and can
cause damage if not carried out properly.
A test to check for possible gas leaks should be carried out
once the equipment has been installed.
The requirements regarding the type and quantity of gas in
each appliance can be found in this manual.
Notes for correct installation:
The place of installation should be a well ventilated room.
The installation site must be free of open fuel and any heat
source that emits gases and fumes.
It is necessary to choose the place where the installation or
maintenance is convenient and where the air inlets and
outlets are perfectly uncovered and unobstructed.
If the indoor unit leaks refrigerant during installation, it is
necessary to immediately turn off the valve of the outdoor
unit and empty the staff room for at least 15 minutes. If the
product is damaged, please repack the product before
installation and contact the supplier of the unit.
It is necessary to avoid placing the indoor unit just above
other electrical appliances, sockets, furniture, beds, sofas or
other furniture.
INDOOR UNIT INSTALLATION
The area where the indoor unit is installed must respect a minimum
separation from its surroundings as shown in the picture below.
55
Publicidad
