Publicidad
Idiomas disponibles
Idiomas disponibles
Condensation drainage from the outside (only for heat pump units)
When the unit is in heating mode, condensed water and frost can be
reliably discharged through the drainage system.
Installation: Install the exterior drainage elbow in the 25mm
diameter hole at the base, and attach it to the drainage hose, so that
the water that forms on the outside can be drained into a suitable
container.
Checks after installation
Electrical safety check
1. If the voltage supplied is the required one.
If there is any fault or bad connection in any of the cables.
3.If the ground wire is correctly connected to the ground.
Safety checks on the installation
1.If the installation is safe.
2.If the water drainage flows correctly.
3.If the wiring and pipes are installed correctly.
4.Check that external materials or tools have been left inside the
unit.
5.Check that the coolant pipe is properly protected.
64
Publicidad
