Descargar Imprimir esta página

Kärcher HD 7/16-4 Cage Manual De Instrucciones página 20

Ocultar thumbs Ver también para HD 7/16-4 Cage:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
Mounting the cable / hose rack
 If required, attach accompanying cable
/ hose rack to the wall.
or
Illustration
 Attach the enclosed cable/hose rack to
the bottom of the device.
Attaching the holder for the trigger
Note:
Not all unit models are equipped with the
holder for the trigger gun.
Illustration
 Attaching the support.
DANGER
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. If they are not in a perfect state
then the appliance must not be used.
Electrical connection
DANGER
Danger of injury by electric shock.
The appliance may only be connected to al-
ternating current.
It is imperative to connect the appliance to
the electric mains by means of a plug. It is
forbidden to permanently connect the appli-
ance to the power supply. The plug serves
for the disconnection from the mains.
Use the extension cord that has an ade-
quate cross-section (see "Technical Data")
and unwind it fully from the cable drum.
For connection values, see type plate/tech-
nical data.
Water connection
Connection to the water supply
According to applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. En-
sure that the connection of your building
water installation on which the high-pres-
sure cleaner is operated is equipped with a
system separator pursuant to EN 12729
Type BA.
Water that was flowing through a system
separator is considered non-drinkable.
20
gun
Start up
CAUTION
Always connect the system separator to the
water supply, never directly to the appliance!
For connection values refer to technical
specifications.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note:
The supply hose is not included.
 Open the water supply.
Drawing in water from open reservoirs
 Screw the suction hose onto the water
connection.
Note:
The suction hose is not included in the
scope of delivery.
If a suction hose with a check valve or filter
is used, the hose must be filled with water.
 Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for approx.
10 seconds - then switch off. Repeat the
procedure for a couple of times.
 Switch off the appliance and fit the noz-
zle again.
DANGER
Risk of explosion!
Do not spray flammable liquids.
If the appliance is used in hazardous areas
(e.g. filling stations) the corresponding
safety regulations must be observed.
Risk of injury! Hold the hand spray gun and
the spray pipe firmly with both hands.
Risk of injury! The trigger and safety lever
may not be locked during the operation.
Risk of injury! Contact Customer Service if
the safety lever is damaged.
Risk of injury from high-pressure water jet.
Slide the safety catch on the trigger gun for-
ward before performing any work with the
appliance.
– 6
EN
Operation

Publicidad

loading