Hartmann Veroval Instrucciones De Uso página 89

Specific
Error
E3
E4
E5
E6
Implausible
measured values
Switch the monitor off if an error symbol appears. Check for all possible causes
and note the 10 golden rules as well as the instructions for self-measurement in
Chapter 2 Important information. Relax for a minute and then take the measure-
ment again.
Possible causes
The cuff was applied too
firmly or too loosely.
There is a system error.
Inflation pressure is
higher than 300 mmHg.
There is a system error.
The batteries are almost
empty.
Implausible measured
values often occur due
to inappropriate han-
dling of the monitor
or mistakes during the
measuring procedure.
Remedy
Apply the cuff so that two fin-
gers fit between the cuff and
the upper arm.
Air tube is not correctly con-
nected to the monitor.
Check that the connector plug is
correctly positioned.
If this error occurs frequently,
you should use a new cuff.
Contact customer service if this
error message appears.
Please rest for at least 1 minute
and take the measurement
again.
Contact customer service if this
error message appears.
Replace batteries.
Please observe the 10 gold-
en rules of blood pressure
measurement (see Chapter 5
'Measuring your blood pres-
sure') as well as the safety
instructions. Then repeat the
measurement.
89
English
GB