Pontec PondoTronic UVC 18 Instrucciones De Uso página 11

Installation and connection
Prerequisite
• The unit head is removed. (→ Dismantling the unit head)
Installing the unit
How to proceed:
 B, C
• Install the unit at least 2 m from the edge of the pond.
• Only install the unit in the permitted positions. This ensures fault-free operation.
• Allow sufficient space for carrying out maintenance work.
• Reinstall the unit head after screwing the casing to the ground. (→ Fitting the unit head)
Establishing the connections
How to proceed:
 D
1. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
2. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
– In the case of a stepped hose adapter with separate union nut, first push the union nut over the hose.
3. Connect the stepped hose adapter with seal to the casing.
– Connect the inlet and outlet.
– Hand tighten the stepped hose adapter.
Commissioning/start-up
Prerequisite
• First switch on the pump, then the UVC clarifier.
• Check all connections for leaks.
Switching ON/switching OFF
• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.
Check the function.
 E
• The function display is lit when the UVC lamp is switched on.
Maintenance and cleaning
NOTE
Do not use aggressive cleaning agents or chemical solutions. These agents can damage the housing, impair the func-
tion of the device and harm animals, plants and the environment.

Only clean the unit from the outside with clear water and a soft brush.
• Recommended cleaning agent for removing stubborn limescale deposits:
– Vinegar- and chlorine-free household cleaning agent.
- EN -
11