Publicidad
Idiomas disponibles
Idiomas disponibles
Norms and declarations of conformity
Our company declares that the stove conforms to
the following norms for the EC European Directive
labelling:
• 2014/30 UE (regulation EMCD) and following
amendments;
• 2014/35 UE (Low Voltage Directive) and following
amendments;
• 2011/65 UE (RoHS 2 directive);
• The New Rules of Construction Products (CPR-
Construction Products Regulation) No. 305/2011
regarding the construction world;
• For installations in Italy, please refer to UNI 10683/98
or following changes. For the water-thermo-sanitary
equipment, let the installer give you the conform-
ity declaration in compliance with L. 37/2008. While
installing the unit respect the local, national and Eu-
ropen rules;
• EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-
3-3; EN 60335-1; EN 60335-2-102; EN 62233, EN
50581.
Safety information
Please carefully read this use and maintenance man-
ual before installing and operating the stove!
If clarification is needed, please contact the dealer or
the Authorized Assistance Center.
• The pellet stove must only be operated in living
environments. This stove, being controlled by an
electronic board, permits a completely automatic
and controlled combustion; the exchange, in fact,
regulates the lighting phase, 5 power levels and the
shut down stage, guaranteeing the safe operation
of the stove.
• The basket used for combustion allows most of the
ash produced by the combustion of the pellets to
fall into the collection compartment. Nevertheless,
check the basket daily, given that not all pellets
have high quality standards (use only quality pel-
lets recommended by the manufacturer).
Responsibility
With the delivery of the present manual, we decline
all responsibility, both civil and penal, for accidents
deriving from the partial or total lack of observance
of the instructions contained herein.
We decline every responsibility derived from im-
proper use of the stove, from incorrect use by the
user, from unauthorized modifications and/or re-
pairs, from the use of replacement parts that are not
original for this model.
The manufacturer declines every civil or penal, direct
or indirect responsibility due to:
46
• Lack of maintenance;
• Failure to observe the instructions contained in the
manual;
• Use in non-conformity with the safety directives;
• Installation in non-conformity with the norms in
force in the country;
• Installation by unqualified or untrained personnel;
• Modifications and repairs not authorized by the
manufacturer;
• Use of non-original replacement parts;
• Exceptional events.
• Use only wood pellets;
• Keep / store the pellets in a cool dry
place;
• Never pour pellets directly on the hearth;
• The thermostove must only be fed with quality 6
mm diameter pellets, A1 certified according to
the UNI EN ISO 17225-2 regulations;
• Before making the electrical connection of the
thermostove the discharge tubes must be con-
nected with the flue;
• The protective grill placed inside the pellet con-
tainer must never be removed;
• The environment where the stove is installed
must have a sufficient exchange of air;
• It is forbidden to operate the thermostove with
the door open or the glass broken;
• Do not use the thermostove as an incinerator;
the thermostove should be used only for the in-
tended purpose;
• Any other use is considered improper and
therefore dangerous. Do not put in the hopper
other than wood pellets;
• When the thermostove is operating, the surfac-
es, glass, handle and tubes become very hot:
during operation do not touch these parts with-
out adequate protection;
• Keep the fuel and other inflammable materials
off the thermostove.
Publicidad
