CANADIAN stove IDRO 17 Manual Del Usuario página 71

Preliminary checks
Before switching on the pellet thermostove, make sure that the pellet hopper is full, the combustion chamber is clean, the
glass door is closed, the power supply plug is connected and the switch on the back is set to "1."
Information on the display
TURNED OFF
21 : 10
22°C P-1
The thermostove is off.
TURNED OFF
TURNED ON
14 : 35
21°C P-2
The stove is in the fi rst ignition phase.
ACCENDE
The glow plug and fume extractor are active.
LOAD PELLET
14 : 35
21°C P-2
LOAD In this phase of the ignition process the stove starts loading the pellets into the brazier.
pellet
The glow plug, the fume extractor and the cochlea engine are active.
FIRE PRESENT
14 : 35
22°C P-1
In this phase of the ignition process the stove starts loading the pellets into the brazier.
FIRE
The fume extractor and the cochlea engine are active.
present
WORK
15 : 18
22°C P-3
The stove is working, in this case at power 3.
WORK
The detected room temperature is 21 ° C. During normal work, the fumes fan, the auger motor
and the room fan are active.
BRAZIER CLEANING
15 : 18
22°C p-2
The stove is cleaning the basket.
BRAZIER
CLEANING
The smoke extractor runs at maximum speed and the pellet load is at minimum.
71