Publicidad
Idiomas disponibles
Idiomas disponibles
Flame-shell cleaning
Every 2-3 days it is important to remove the steel flame-
shell in order to clean it and remove the dirty that may fall
during the cleaning of the exchange pipes.
Shutting the Thermostove down
In the period when the Thermostove is out of use it
must be disconnected from the electricity mains. For
greater safety, especially if there are children around, we
recommend removing the power cable from the rear of the
Thermostove.
Before placing the Thermostove in storage, you should
remove all pellets from the hopper with a vacuum cleaner
with a long extension. If the fuel is left in the hopper, it
may get damp, stick together, and be difficult to light at
the beginning of the next season. If pressing the main
switch (located on the back of the Thermostove) does
not make the control panel display light up, it could mean
that the service fuse needs replacing. On the rear of the
Thermostove there is a fuse holding compartment which is
located underneath the supply socket. With a screwdriver
open the cover of the fuse holding compartment, and re
place the fuse if necessary (3,15 AT delayed type). Plug
the unit back in and press the main switch.
CLEANING BY THE TECHNICAL
Check every year
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the smoke fan for
cleaning of the same. Perform the task with the greatest
care not to bend the fan blades.
Clean flue
Clean the flue system especially near the fittings to "T",
curves and any horizontal sections. Is necessary to check
and remove any deposit of ash and soot before the same
clogging the passage of smoke.
Cleaning the exchanger
Once a year is also recommended to clean the upper
compartment of the exchanger. To make a proper clean-
ing is recommended to suck the ash, remove all horizontal
joints with a screwdriver, then again suck the ash.
Lift the upper door that covers the tube by unscrewing the
screws. Pull out the 10 soft brush and wipe with a clean
10 exchanger tubes.
Perform cleaning after removing the springs inserted
in each pipe. The operation is simple by removing the
springs from the horizontal pin to which they are attached.
To do this, the horizontal pin can be pulled through a hole
in the wall of the thermostove body.
81
Publicidad
