Publicidad
Idiomas disponibles
Idiomas disponibles
6. After the charging process is complete:
a Unplug the mains plug of the charger.
b Disconnect the battery connector from the charger.
c Connect the device-side battery connector to the bat-
tery-side battery connector.
Operation
ATTENTION
Risks during operation
Danger of injury
Release the safety switch in the case of danger.
Filling with operating materials
Filling fresh water
1. Open the fresh water tank cap.
2. Fill fresh water (maximal 122 °F (50 °C)) to the lower
edge of the filling nozzle.
Note: The fresh water hose can be clamped with the
hose holder during filling.
3. Close the fresh water tank lock.
Notes on detergents
WARNING
Risk of damage to the device!
If unsuitable detergents are used, the device may get dam-
aged.
Use only recommended detergents. The operator carries
all increased risks relating to operational safety and in-
creased risk of accidents if using other detergents.
Use only detergents free of solvents, salt and hydrofluoric
acid.
Adhere to the safety instructions stated on the detergent
packaging.
Note
Do not use heavily foaming detergent.
Recommended detergents
Application
Floor maintenance cleaner extra low
foaming with EU Ecolabel
Highly wetting universal cleaner
Intensive alcohol cleaner for floors and
surfaces. Well-suited for hard rock
such as granite
Fine stone cleaner, surfactant-free
Universal decoater, suitable for linole-
um
Acidic vending machine basic cleaner.
Suitable for sanitary areas and con-
struction cleaning
Industrial maintenance cleaner
Industrial basic cleaner and alkaline
decoater
Surface disinfectant cleaner
Detergent
1. Fill the detergent into the fresh water tank.
Note: The cap for the fresh water tank filling hole can be
used for measuring the correct quantity of detergent. It
has a measuring scale marked on the inner side.
10
1. Adjust the water volume via the regulating knob to suit
Note
Perform initial cleaning tests with a low water volume. In-
crease the water volume step by step until achieving the
desired cleaning result.
Note
The cleaning head continues operating without a liquid
supply if the fresh water tank is empty.
The inclination must be adjusted so that the suction lips of
the suction bar make even contact with the floor over the
entire length of the suction bar.
1. Loosen the screw.
1
2. Adjust the inclination of the suction bar.
3. Tighten the screw.
Detergent
The height adjustment affects the bending of the suction
APPROX. 50 C
lips on contact with the floor.
1. Push the device a small distance forwards.
RM 756
2. Compare the bending of the suction lips with the figure
RM 755
RM 753
RM 754
RM 751
RM 69
RM 752
RM 732
´
1
2
3
3. Unscrew the screw.
English
Adjusting the water volume
the degree of soiling of the floor covering.
Adjusting the suction bar
Adjusting the inclination
Screw
Adjusting the height
below.
1 2
3
Spacer roller with holder
Washer
Screw
1
10 mm
Publicidad
