Only load the device with the assistance of another person
or by using the drive.
1. Press the cleaning head lever down and latch it in place.
2. Raise the suction bar.
3. Turn the key-operated switch to "1".
4. Select the travel direction at the travel direction switch.
5. Pull the safety switch towards the push handle.
6. When transporting in vehicles, secure the device
against slipping and tipping over according to the appli-
cable guidelines.
1.
7. First fit the strap under the waste water tank.
Storage
CAUTION
Risk of injury and damage!
The device may tip over on sloping surfaces.
Be aware of the weight of the device during storage.
ATTENTION
Frost
Destruction of the device through freezing water
Drain all water from the device.
Store the device in a frost-free location.
● This device may only be stored indoors.
● Before prolonged storage:
1. Bring the battery/batteries to a state of charge between
30% and 50%.
2. Disconnect the charger from the battery connector.
3. Press the button on the battery for 20 seconds to put the
battery into sleep mode.
Button
1
Charge indicator
2
Battery
3
12
The LEDs of the charge indicator all light up and go out
one after the other. The charge indicator will now no
longer react when the button is pressed briefly.
Note
For devices with multiple batteries, this procedure only
needs to be carried out on one battery. The other batteries
take over the sleep mode automatically.
Care and maintenance
DANGER
Risk of injury!
The device may start moving unexpectedly and cause in-
jury.
Turn the key-operated switch to "0" and remove the key
before performing any work on the device.
Pull out the charger mains plug.
Drain and dispose of the waste water and fresh water.
Safety inspection/maintenance contract
You can agree on regular safety inspections or close a
maintenance contract with your dealer. Please seek advice
on this.
2.
ATTENTION
Improper cleaning
Risk of damage.
Do not spray the device with water.
Do not use aggressive cleaning agents.
A detailed description of the individual maintenance work
is provided in Chapter Maintenance work.
Drain the waste water.
Rinse the waste water tank with clear water.
Clean the exterior of the device using a damp cloth, wet-
ted with a mild washing lye.
Check the fluff filter and clean if required.
Clean the coarse dirt filter.
Clean the suction lips, check for wear and adjust the
height or replace if necessary.
Check the disc brushes for wear and replace if neces-
sary.
Charge the battery.
If the charging state of the battery is below 50%,
charge the battery fully and without interruption.
If the charging state of the battery is above 50%, only
recharge the battery if the entire operating duration
will be required when next used.
A detailed description of the individual maintenance work
is provided in the chapter "Maintenance Work".
1. Drain the fresh water tank and flush out deposits.
2. Clean the fresh water filter.
3. Clean the float and fluff filter.
4. Check battery poles for oxidation, brush off if necessary.
Make sure the connection cables are firmly in place.
5. Clean the seals between the waste water tank and the
cover, check for leaks and replace if necessary.
6. For longer periods of disuse, shut down the device when
the batteries are fully charged. Fully charge the battery
at least once a month.
English
Maintenance intervals
Each time after use
Monthly