Kärcher T 7 Plus T-Racer Manual Del Usuario página 7

1. Attach the T-Racer to the high-pres-
sure gun with the extension tube.
a Completely unscrew the union
nut.
b Press the bayonet of the exten-
sion tube into the socket on the
high-pressure gun.
c Turn the high-pressure gun 90°
until it clicks into place.
2. Tighten the union nut.
3. Adjust the height adjustment of the
rotor arm according to the cleaning
surface.
4. Unlock the lever of the trigger gun.
5. Pull the lever of the trigger gun.
The device switches on.
6. Clean the floor area, while guiding
the T-Racer over the floor area with-
out exerting any force.
Cleaning the wall surface
1. Attach the T-Racer to the high-pres-
sure gun with the lower extension
tube (green marking).
Do not use the upper extension tube
(yellow marking).
a Completely unscrew the union
nut.
b Press the bayonet of the lower ex-
tension tube (green marking) into
the socket on the high-pressure
gun.
c Turn the high-pressure gun 90°
until it clicks into place.
2. Tighten the union nut.
3. Unlock the lever of the trigger gun.
4. Pull the lever of the trigger gun.
The device switches on.
5. Clean the wall surface.
Height adjustment of rotor arm
The distance between the high-pres-
sure nozzles and the cleaning surface
is changed by the height adjustment of
the rotor arm.
Adjust the height adjustment of the ro-
tor arm according to the cleaning task.
For powerful cleaning of stubborn
dirt on robust surfaces, e.g. tiles,
concrete, stone:
1. Set the height adjustment of the ro-
tor arm to "HARD".
For cleaning sensitive surfaces:
2. Set the height adjustment of the ro-
tor arm to "SOFT".
Foot switch for surface cleaning
For cleaning large areas:
1. Press the surface cleaning foot
switch.
English 7