Kärcher T 7 Plus T-Racer Manual Del Usuario página 8

A jet of water emerges from both
high-pressure nozzles in the rotor
arm.
Foot switch for edge and corner
cleaning
Note
Guide the T-Racer along the corner to
achieve an optimal cleaning result.
For cleaning corners and edges:
1. Press the foot switch for edge and
corner cleaning.
A jet of water emerges from the front
high-pressure nozzle.
Foot switch for rinsing function
Note
The device has a rinsing function for
pre-watering or rinsing the cleaned
surface.
For rinsing:
1. Press the rinsing function foot
switch.
A powerful, but not a high-pressure
water jet emerges from the flushing
nozzle.
After use
After use, rinse the device with a soft
jet of water.
 Remove the T-Racer and any exten-
sion tubes from the high-pressure
gun.
 Rinse the T-Racer with the high-
pressure gun (without additional ac-
cessories) or wipe it with a damp
cloth.
Transport
WARNING
Risk of injury, risk of damage!
Be aware of the weight of the device
during transportation.
Stow or secure the device in accor-
dance with the applicable guidelines so
8
that it does not slide or jostle around
during transport.
1. Stow or secure the device so that it
does not slide or jostle around in the
vehicle when accelerating, braking,
cornering or in the event of an acci-
dent.
Store the device in a frost-free place.
Care and service
Installing/removing nozzles
The procedure described applies to all
available nozzles on the device.
1. Remove the clip.
2. Pull out the high-pressure nozzle.
3. Insert the high-pressure nozzle.
4. Mount the clip.
Cleaning the high-pressure
1. Remove the high-pressure nozzle.
2. Rinse the high-pressure nozzle with
clear water in both directions. If nec-
essary, replace a damaged high-
pressure nozzle.
3. Install the high-pressure nozzle.
English
Storage
nozzle