Techno Line WS 9172 Manual De Instrucciones página 8

A – Front / display
A1 – PM/AM icon
A2 – MIN/MAX icon (indoor)
A3 – Indoor temperature
A4 – MIN/MAX icon (outdoor)
A5 – Outdoor temperature
B – Back / buttons and case
B1 – Hanging hole
B2 – Ventilation holes
B3 – "MAX/MIN / +" button
C – Outdoor sensor
C1 – Radio signal LED
C2 – Hanging hole
C3 – Channel switch
Functions

Manual time setting

Temperature alternatively in °C or °F.

12/24 hour time display.

Display of indoor/outdoor temperature and MIN/MAX indoor/outdoor
temperature

Low battery indicators for station and sensor

Wall mounting or table standing.
Initial operation

Place the station and the sensor next to each other on a flat surface
and open the battery compartment of both station and sensor. Leave
the sensor on the channel set as factory setting for this station (A).

Insert 2x AAA batteries observing correct polarity (+/- icons) into the
outdoor sensor and shortly after (within 30 seconds) insert 2x AAA
batteries observing correct polarity (+/- icons) into the base station.

The LCD of the station will show all segments for 2 seconds and then
start to work. Once the outdoor temperature is received, close the
battery compartment covers again. Place the sensor and the station
accordingly to safety hints.
Notes

Place the outdoor sensor protected from rain, wind and direct sunlight
A6 – Time
A7 – Low battery icon (station)
A8 – Low battery icon (sensor)
A9 – Sensor reception icon
B4 – "°C/°F / SET" button
B5 – Battery compartment
C4 – Battery compartment
C5 – Standing foot
EN2