Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
IMPORTANT! When vacuuming large quantities
of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle
opening to allow air inflow. The machine is fitted
with a float valve that stops the suction action
when the collection tank reaches its maximum
capacity. You will notice an increase in motor
speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid
into a suitable receptacle or drain. To continue
vacuuming, refit the collection tank with the drain
cap. After wet vacuuming, turn the machine off
and remove plug from power supply. Empty the
collection tank, clean, and dry the inside and
outside before storage.
REMEMBER! The foam wet filter must be
removed after wet vacuuming and the cartridge
filter must be installed before dry vacuuming again.
FIG. 25
FIG. 26
FIG. 27
FIG. 28
FIG. 29
FIG. 30
BLOWER OPERATION
See Figures 31-37.
This wet/dry vacuum has blowing capabilities.
To use the blower feature follow the instructions
listed.
WARNING:
Always wear safety goggles complying with ANSI Z87.1
(or in Canada, CSAZ94.3) before using blower.
WARNING:
Keep bystanders clear from blowing debris.
WARNING:
Wear a dust mask if blowing creates dust that might
be inhaled.
10 English
Publicidad
