Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
FIG. 23
FIG. 24
• Verify that the power cord is disconnected from
the outlet.
• In order to prepare your vacuum for dry
vacuuming, make sure the cartridge filter
completely covers the filter cage against the
power head. Your wet/dry vacuum comes with
the cartridge filter pre-installed. For installation
instructions, see page 13.
• Place the filter retainer on the top of the
cartridge filter and tighten down by turning the
retainer handle clockwise.
• Optional: For improved dust filtration, fit the dust
bag flange onto the inlet port, taking care not to
damage the bag.
• Place the power head back on the collection
tank and secure it in place using the latches.
• Insert the locking end of the hose into the
vacuum port on the collection tank and lock
into place.
• Push the required attachment onto the free end
of the hose or extension wand.
• Verify that the switch is in the 'O' OFF position
before plugging the power cord into the power
outlet. Plug the power cord into the outlet.
• Turn the motor on by flipping the switch to the
'I' ON position and begin vacuuming.
• Once you have completed vacuuming, flip the
switch to the 'O' OFF position and unplug the
power cord from the outlet.
O = OFF
I = ON
DO NOT USE THE CARTRIDGE FILTER FOR
LIQUID VACUUMING.
DO NOT USE THE DUST BAG FOR LIQUID
VACUUMING.
LIQUID VACUUMING
See Figures 25-30.
WARNING:
Be sure to read, understand, and apply information
entitled "SAFETY INFORMATION". Do not vacuum
in areas with flammable gases, vapors, or explosive
dusts in the air. Flammable gases or vapors include but
are not limited to: lighter fluid, solvent type cleaners,
oil-based paints, gasoline, alcohol, or aerosol sprays.
Explosive dusts include but are not limited to: coal,
magnesium, grain, or gun powder. To reduce the risk
of health hazards from vapors or dust, do not vacuum
toxic materials.
WARNING:
Do not plug the power cord into the power outlet.
Make sure the plug is disconnected before changing
the filters.
• Verify that the power cord is disconnected from
the outlet. Make sure that the collection tank is
clean and free of dust and dirt.
• Remove the cartridge filter, then carefully install
the foam wet filter over the filter cage and place
the power head back on the collection tank. For
foam wet filter installation instructions, see page
14.
DO NOT USE THE CARTRIDGE FILTER FOR
LIQUID VACUUMING.
DO NOT USE THE DUST BAG FOR LIQUID
VACUUMING.
• Insert the locking end of the hose into the
vacuum port on the collection tank and lock
into place.
• Push the required attachment onto the free end
of the hose or extension wand.
• Verify that the switch is in the 'O' OFF position
before plugging the power cord into the power
outlet. Plug the power cord into the outlet.
• Turn the motor on by flipping the switch to the
'I' ON position.
• Once you have completed vacuuming, flip the
switch to the 'O' OFF position and unplug the
power cord from the outlet.
• After use, empty the collection tank by
unscrewing the drain cap. Drain liquids into a
suitable receptacle or drain. Once the collection
tank is cleaned and dried, refit the drain cap to
the collection tank.
9 English
Publicidad
