Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
INSTALLING FOAM WET FILTER
See Figures 48-50.
• Verify that the power cord is disconnected from
the outlet.
• Remove the power head and place in an upside-
down position. Follow instructions to remove
the cartridge filter on page 14.
• Carefully slide the foam wet filter down over the
filter cage making sure the cage is completely
covered.
• Place the power head onto the collection tank.
FIG. 48
FIG. 49
FIG. 50
CLEANING FOAM WET FILTER
See Figures 51-52.
• With the removed power head in an upside-
down position, carefully remove the foam wet
filter.
• Use a mild soap and water solution to wash the
foam wet filter and rinse with clean water.
• Allow the wet filter to air dry for 24 hours before
installing onto the filter cage.
FIG. 51
FIG. 52
14 English
Publicidad
