Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
EMPTYING THE COLLECTION TANK
See Figures 38-41.
WARNING:
Always disconnect the plug from the power outlet
before removing the power head from collection tank.
• Verify that the power cord is disconnected from
the outlet.
• Disconnect the hose from the vacuum.
• Undo the latches and remove the power head
from the collection tank. Place power head on
a soft, clean surface upside down.
• Clear all dirt or debris from the collection tank
and hose into a proper waste container.
• Clean or replace the filters.
• Check the hose, attachments, and power cord
to ensure that they have not been damaged.
• Place the power head back onto the collection
tank and secure latches.
IMPORTANT! Clean or change the filter regularly
for best performance. ALWAYS USE THE
CARTRIDGE FILTER FOR DRY VACUUMING. If
the machine is used without the cartridge filter, the
motor will burn out and the warranty will be voided.
Always keep spare filters on hand.
NOTICE! The filters included are made of high-
quality materials designed to stop small dust
particles. The cartridge filter should be used for
dry pick-up only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it will
clog quickly and be very difficult to clean. Handle
the filter carefully when removing it for cleaning
and replacing it. Check the filters for tears or small
holes. A small hole can let dust pass through and
out of the filter. Do not use a filter with holes or
tears; replace it immediately.
STORAGE
Before storing your vacuum, the collection tank
should be emptied and cleaned. The accessories
should be cleaned and stored so they can be
readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be
performed only by qualified service personnel
using only identical replacement parts.
FIG. 38
FIG. 39
FIG. 40
FIG. 41
12 English
Publicidad
