3M PELTOR ProTac III Manual Del Usuario página 11

• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable
batteries.
• To properly dispose of the battery, follow local solid
waste disposal regulations.
• Only use AA or AAA non-rechargeable (as applicable)
or 3M PELTOR Ni-MH rechargeable LR6NM or
TM TM
LR3NM (as applicable) batteries.
2.4. U.S. EPA REQUIRED STATEMENTS
Improper fit of this device will reduce its effectiveness in
attenuating noise. Consult the enclosed instructions for
proper fit.
Although hearing protectors can be recommended for
protection against the harmful effects of impulsive noise,
the Noise Reduction Rating (NRR) is based on the
attenuation of continuous noise and may not be an
accurate indicator of the protection attainable against
impulsive noise such as gunfire (wording required by
EPA).
The level of noise entering a person's ear, when hearing
protector is worn as directed, is closely approximated by
the difference between the A-weighted environmental
noise level and the NRR.
Example
1. The environmental noise level as measured at the ear
is 92 dBA.
2. The NRR is 19 decibels (dB).
3. The level of noise entering the ear is approximately
equal to 73 dB(A).
CAUTION: For noise environments dominated by
frequencies below 500 Hz the C-weighted environmental
noise level should be used
3. APPROVALS
3.1. EU AND GB APPROVALS
EU
Hereby, 3M Svenska AB declares that the PPE type
hearing protector is in compliance with Regulation (EU)
2016/425 and other appropriate directives to fulfill the
requirements for the CE marking.
The PPE is audited annually by SGS Fimko Ltd.,
Takomotie 8, FI-00380 Helsinki, Finland, Notified Body
No. 0598 and type approved by PZT GmbH, Notified
Body No. 1974, Bismarckstrasse 264 B, 26389,
Wilhelmshaven, Germany.
The product has been tested and approved in
accordance with EN 352-1:2020/EN 352-3:2020, EN
352-4:2020, EN 352-6:2020, EN 352-8:2020.
GB
Hereby, 3M Svenska AB declares that the PPE type
hearing protector is in compliance with Personal
Protective Equipment Regulations (Regulation 2016/425
as brought into UK law and amended).
The PPE is audited annually, and type approved by SGS
United Kingdom Limited, Rossmore Business Park,
Ellesmere Port Cheshire CH65 3EN, UK, Approved Body
No. 0120. The product has been tested and approved in
accordance with EN 352-1:2020/EN 352-3:2020, EN
352-4:2020, EN 352-6:2020, EN 352- 8:2020.
0120
EU AND GB
The applicable legislation can be determined by reviewing
the Declaration of Conformity (DoC) at www.3M.com/
peltor/doc. The DoC will also show if some other type-
approvals are also applicable. When retrieving your DoC,
please locate your part number. The part number of your
earmuffs can be found in the battery compartment in the
left cup. Please see picture below.
A copy of the DoC and additional information required
in the Regulations and Directives can also be obtained
by contacting 3M in the country of purchase. For contact
information, see last pages of this user instruction.
3.2. FCC AND IC INFORMATION
This device complies with Part 15 of the FCC rules and
ISED Canada license-exempt Radio Standards
Specifications. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesirable operation.
NOTE: This device has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This device
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
3
EN