6. Press BODY FAT to measure the body fat tissue. You need to hold both sensor
contacts on the handlebar with your hands to obtain a result. After 8 seconds, the
display reads a change of the BMI and the body fat percentage.
7. Press and hold the RESET button for 2 seconds to reset all the settings made.
8. Press TOTAL RESET to reset and restart the display control panel.
9. Manually set the resistance level of the flywheel assembly by operating the
resistance setting dial – the arrow tip on the dial is to be set at the desired level
(one of the eight available).
10. Grasp the handlebars and place your feet firmly on the pedals. Careful: the
pedals will shift when stepping on the trainer. Start your training; the legs should
move along an ellipse. Adjust the settings as required.
CAUTION! If the product will not be used for a long time, remove the batteries and
fold down the product.
3.5. Cleaning and maintenance
a)
Before cleaning and when the appliance is not in use, unplug it from the mains
and remove the batteries.
b)
Use non-corrosive agents only for cleaning the surfaces.
c)
After each cleaning, dry all components well before the appliance is used
again.
d)
Store the appliance in a dry and cool place, protected from moisture and direct
sunlight.
e)
Do not spray the appliance with a stream of water and do not immerse it in
water.
f)
Regularly inspect the appliance for technical defects and damage.
g)
Remove the battery from the appliance if you do not intend to use it for a long
time.
h)
After each training session, use a soft cloth damp with water and some
disinfectant (if required) to clean the handlebars.
i)
Do not clean with any sharp and/or metal implements (e.g. a wire brush or a
metal scraper) as these may damage the surface of the appliance.
j)
Do not clean the unit with acidic substances, medical products, thinners, fuel,
oil or other chemicals as they may damage it.
SAFE DISPOSAL OF DISPOSABLE/RECHARGEABLE BATTERIES
The appliance is intended for AA batteries.
Remove the spent batteries from the appliance in the reverse order of installation.
Hand the batteries over to a dedicated battery disposal service.