Silvercrest SSMC 600 B1 Instrucciones De Uso página 11

4) Press the lid 2 firmly down onto the blender 3. Close the lid 2 by turning
it clockwise to position
the pouring spout on the blender 3 is closed. The motor cannot start until
the lid 2 is fitted flush.
Fig. 1
5) Press the measuring cap 1 into the lid as far as the stop.
6) Place the completely filled and closed blender 3 with the handle to the
right on the motor block 6. Make sure that the arrow
points to the
back and forth if it does not immediately sit properly. The motor cannot start
until the blender 3 is fitted flush to the motor unit.
Selecting the speed setting
Once the blender 3 is filled and sitting completely closed on the motor block 6,
you can switch on the appliance.
Set the switch 5 to ...
■
Level 1 – 3
for liquids or soft foodstuffs, for mixing, blending and stirring
■ Level 3 – 5
for more solid foods or for chopping
■ Level P (pulse function)
for short, powerful impulse operation, e.g. for crushing ice cubes or when
cleaning. To prevent overloading the motor, the switch 5 does not lock in this
position. Therefore, hold the switch 5 in this position for short periods only.
NOTE
Fill the blender 3 with a maximum of 180 g of ice cubes.
►
Otherwise, the ice cubes will not be crushed optimally.
│ GB │ IE
■ 8
until it audibly engages (see Fig. 2). Ensure that
Fig. 2
arrow on the motor block 6. Turn the blender 3 slightly
on the blender 3
SSMC 600 B1