Pramac P2000i Manual Del Operador página 14

INVERTER GENERATOR – P2000i
2.3 Control Functions
ECONOMY THROTTLE
Throttle
When the Throttle switch is in the "I" position the throttle controls the engine
speed according to the connected electrical load. The results are better fuel
consumption and less noise. When the switch is in the "O" position the engine
runs at 4,500 rpm regardless of the electrical load.
NOTE
The Throttle must be "O" when using electrical devices that require a large starting current,
such as a compressor, pump, or refrigenator.
Led Indicators
The LED Indicators assist in communicating proper and improper functions of
the unit.
Output Indicator (Green)
The Output Indicator comes on when the engine starts and produces power.
Overload Alarm (Red)
The Overload Alarm comes on when a connected device requires more
power than the generator is able to produce, the inverter control unit
overheats, or the AC output voltage rises above rated values. The Output
Indicator (Green) will go off and the Overload Alarm (Red) will stay on, but the
engine will continue to run.
When the Overload Alarm Light comes on and power generation stops,
proceed as follows:
14