Pramac P2000i Manual Del Operador página 33

5.3 Engine Oil Replacement
Initial replacement of the engine oil is after one month or 20 hours of
operation.
1. Place the generator on a level surface and warm up the engine for
several minutes. Then stop the engine and turn the Fuel Petcock knob to
"O" and the Fuel Tank Cap Air Vent knob to "OFF".
2. Remove the screws 1 and then remove the cover 2.
3. Remove the oil filler cap.
4. Place an oil pan under the engine. Tilt the generator to drain the oil
completely.
5. Return the generator to a level surface.
NOTE
DO NOT tilt the generator when adding engine oil. This could result in overfilling and
damage to the engine.
6. Add engine oil to the upper level as seen in the diagram 1.
Recommended engine oil: YAMALUBE 4 (10W-40), SAE 10W-30 or MOW-40, SAE#30, SAE#20,
SAE10W.
Recommended engine oil grade: API Service SE type or higher Engine oil quantity: 0.4L (0.42US
qt, 0.035 Imp qt)
7. Install oil filler cap, cover, and screws.
INVERTER GENERATOR – P2000i
33