Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Before cleaning always make sure that the machine
is unplugged and that it has been allowed to cool.
NEVER use alkaline detergents, solvents, alcohol or
aggressive substances.
It is advisable to rinse the water tank everyday and
fill it with fresh water. Empty and clean the used
cartridge/drop collection draw every 2-3 days. Do
not use microwave or traditional ovens to dry the
machine or its parts. NEVER use alkaline detergents,
solvents, alcohol or aggressive substances. Do not
immerse the machine in water. Unless otherwise
specified, all machine components (except electric
components) that cannot be dismantled should
be washed in cold or lukewarm water using non-
abrasive cloths or sponges.
CLEANING STEAM ARM
Remove the tip of the steam arm by pulling it
downwards and wash it in a dishwasher or with
water. Clean the steam arm with a wet cloth and
replace the tip.
CLEANING THE DISPENSING SPOUT
Pressing on the tab to the rear, pull the dispens-
ing spout downwards until it comes away. Re-
move the inside of the dispensing spout and
wash it with lukewarm water. Having put the
dispensing spout back together, put it back in
its place by carrying out the same actions in re-
verse, checking that it is in the correct position.
MAINTENANCE AND CLEANING
CLEANING THE USED CARTRIDGE/DROP
COLLECTION DRAWER
Remove the used cartridge/drop collection
1
drawer (the drawer can hold up to a maximum
of 12 cartridges).
Lift the cup support rack and the drawer cover.
2
Empty the used cartridge and liquids tray. Wash
3
all parts with cold or lukewarm water, then dry
them and put back together.
Publicidad
