Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The machine doesn't turn on.
LEDs flash quickly.
The cartridge load lever will not
return to a central position.
The pump is noisy.
The machine doesn't dispense any
coffee.
Coffee is not hot enough.
The coffee does not come out or
comes out in drops.
The coffee comes out too quickly,
the espresso crema does not form.
Milk or cappuccino froth doesn't
form.
No hot water or steam dispensed.
For any problems not addressed by the above table or if the suggested solutions do not resolve them, contact a Lavazza service centre.
· Voltage: 220-240 V 50/60 Hz
· Total power: 1000 W
· Capacity water tank: 1.4 L
· Dimensions: Height 36 cm - Width 23 cm - Depth 34 cm
· Weight: 5,6 kg
TROUBLESHOOTING
Possible causes
»
Machine not plugged in to
electricity source.
»
The machine has broken down.
»
Used cartridge/drop collection
drawer is full.
»
Incorrectly inserted cartridge.
»
The tank needs filling with water.
»
Filter inserted incorrectly.
»
Unsuitable temperature.
»
Hot water/steam option
selected.
»
Cartridge load lever in raised
position.
»
The cups are cold.
»
The machine was not at the
correct temperature when the
coffee dispenser button was
pressed.
»
Blocked dispensing spout.
»
The cartridge has already been
used.
»
Milk unsuitable.
»
Milk is not cold enough.
»
Steam dispensing spout is
clogged.
»
Clogged steam/hot water arm.
»
Insufficient water in the tank.
»
Filter not inserted correctly.
TECHNICAL CHARACTERISTICS
For the technical characteristics refer to the data plate on the machine.
Solution
»
Check it is plugged in correctly.
»
Contact customer services or a service centre.
»
Empty the used cartridge/drop collection
drawer.
»
Lift the cartridge load lever and correctly
insert the cartridge.
»
Top up with fresh drinking water and repeat
the hydraulic circuit loading.
»
Check that the Brita® filter is inserted and re-
peat the loading of the hydraulic circuit (see
the instructions supplied with the filter).
»
Wait until the ideal temperature has been
reached.
»
Return the hot water/steam dispenser button
to a central position.
»
Lower the cartridge load lever.
»
Pre-heat the cups using hot water.
»
Wait until the machine light remains lit.
»
Clean the dispensing spout (see maintenance
and cleaning).
»
Insert a new cartridge.
»
Use fresh semi-skimmed milk.
»
Use milk at refrigerator temperature.
»
Clean the steam dispensing spout with a
needle and clean the arm.
»
Clean the arm (see maintenance and clean-
ing). If the problem persists clean the dispens-
er hole with a thin needle, making sure that it
is free of blockages. Then turn on the machine
and dispense a small quantity of steam.
»
Top up with fresh drinking water and repeat
the hydraulic circuit loading.
»
Check that the Brita® filter is inserted and re-
peat the loading of the hydraulic circuit (see
the instructions supplied with the filter).
· Collection drawer: 12 cartridge
· Materials used for the machine body: Thermoplastic
2006/42 CE – 2004/108 CE – 2006 /95 CE
E N
Publicidad
