Publicidad
Idiomas disponibles
Idiomas disponibles
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your Freezer
Before storing foods in your Freezer, turn the Freezer on and wait for 24 hours, to make sure it
is working properly and to allow the Freezer to fail to the correct temperature.
START
Testing
1. Clean the parts of the Freezer with lukewarm water containing a little neutral detergent and
with clear water, and wipe them dry.
Notes: Electric parts of the Freezer can only be wiped by dry cloth.
2. Turn the thermostat knob to the "4" position, turn on electricity. The compressor begins to
work.
3. Open the door 30 minutes later, if the temperature in the Freezer decreased obviously, it
shows that the Freezer system works well. When the Freezer operates for a period of time,
the temperature controller will automatically set the temperature within limits it opens.
Adjusting the temperature
1. The temperature in the Freezer is controlled by the temperature controller installed inside
the Freezer. Should start putting food in the freezer after 2-3 hours of the operation
starting.
2. The marks on the knob are the temperature grades, NOT the exact degrees of
temperature. "0" is "OFF" and "7" represents the lowest temperature.
3. Please start with the knob set to position "4". Then adjust according to your requirements.
NOTE: The Freezer may not operate at the correct temperature if it is in a particularly hot
or cold room nor is you open the Freezer door too often.
- 27 -
Publicidad
