LUND 68272 Manual De Instrucciones página 12

Remove the power cord plug from the socket. Allow the sieves to cool down and proceed with their disassembly, starting with the
lid and gradually disassembling the sieves one by one from the highest to the lowest.
After removing the food from the sieves, proceed with the maintenance of the sieves, lid and base.
Recommendations for the food drying
Dried pieces of fruit and vegetables can be used as snacks or as food additives. Dried products retain their taste and nutritional
values. Dried food may diff er in appearance or taste from products available in shops because preservatives and dyes are not
added during drying.
Before drying, it is recommended to note the weight of the products and then the time and temperature of drying. This will make it
easier to determine operating conditions in the future.
The drying time of the products depends on: - the thickness or size of the pieces, - the number of sieves used for drying, - the num-
ber of products placed in the dehydrator, - the humidity of the air around the dehydrator, - personal preference for drying eff ects.
If during the drying process uneven eff ects are observed, the position of the sieves should be periodically changed if the construc-
tion of the appliance allows it.
Dried food should be placed in containers only after it has completely cooled down. The container for storing dried food products
should be tight. It is recommended to use vacuum containers. After placing the products in the container, seal the container tightly
and then extract as much air as possible. Store food in containers in dark and cool rooms. The storage temperature should not
exceed 15 C. Do not place dried food directly in metal containers. Periodically check the condition of dried food.
O
If, for any reason, it is necessary to interrupt the drying process, food should be removed from the sieves and placed in plastic
bags or containers and then stored in the freezer. Before resuming drying, the products should be defrosted. Do not refreeze
products that have already been defrosted.
Appliance maintenance
CAUTION! All maintenance must be carried out with the appliance switched off . To do this, unplug the power cord from the socket.
The appliance is used to prepare food placed directly on the sieves, therefore care must be taken to maintain proper hygiene so
that the preparation of food is safe.
Sieves and lid should be washed with a jet of running water or by immersing it in water. Use a mild dishwashing detergent. Clean
with a soft cloth, a soft sponge or a soft brush. Do not use aggressive or abrasive cleaning agents due to the risk of the sieve and
lid surfaces dulling.
After cleaning is fi nished, dry the sieve and the lid thoroughly before placing them on the base.
Sieves and the lid are not suitable for cleaning in mechanical dishwashers or with high-pressure water jet.
Clean the base / housing with a slightly damp cloth, then dry with a clean, dry cloth.
Caution! Never immerse the electric appliance (base) in water or any other liquid.
Do not use solvents, caustics, alcohol, petrol or abrasives for cleaning.
Clean the ventilation openings with a vacuum cleaner.
Before using the appliance for the fi rst time, after cleaning the sieves, lid and base / housing, run the dehydrator for thirty minutes
at its maximum temperature without placing any food inside. During this time, it is possible that smoke or odour may be emitted
from the appliance. After fi nished operation, allow the appliance to cool down and then wash the sieves and lid again and clean
the base. This will allow to remove the remains of chemical agents used in the appliance components manufacture.
Appliance storage
If the appliance will not be used for an extended period of time, disconnect it from the socket.
During storage, keep the appliance indoors, and make sure it is not exposed to dust, dirt, or moisture. It is recommended to store
the appliance in its original packaging.
Store the appliance in operating position. Do not stack products in layers. Do not place anything on the product during storage.
SPECIFICATION
Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Protection class
Sieve dimensions
Max. load per sieve
Appliance dimensions (H x W x D)
Net weight
O R I G I N A L
12
GB
Unit
[V~]
[Hz]
[W]
[cm]
[kg]
[cm]
[kg]
I N S T R U C T I O N S
Value
68272
220 – 240
50 / 60
420 - 500
I
32.5 x 30
0.5
32 x 34.5 x 45
3
Value
68273
220 – 240
50 - 60
600 - 700
I
32.5 x 30
0.5
42 x 34.5 x 45
4.3