Descargar Imprimir esta página

SICK WTS26 Manual De Instrucciones página 6

Ocultar thumbs Ver también para WTS26:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
4
Mounting
5
Electrical installation
8020355 | SICK
Subject to change without notice
Fixing hole, Ø 5.2 mm
3
Connection
4
LED indicator green: Supply voltage
5
active
LED indicator yellow: Status of
6
received light beam
Press-turn element: Adjusting the
7
sensing range
BluePilot blue: Sensing range dis‐
8
play
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
Note the sensor's maximum permissible tightening torque of < 1,3 Nm.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
Male connector connection: Note pin assignment.
Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanations of the connection diagram
MF (pin 2 configuration) = external input, teach-in, switching signal
Q
/C = switching output, IO-Link communication
L1
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
(table 1
and
table
2).
4
MOUNTING
5

Publicidad

loading