Make A Call - JVC KD-T922BT Manual De Instrucciones

Bluetooth®
Improve the voice quality
While talking on the phone...
1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
[LEVEL –10] to [LEVEL +10] ([LEVEL –04]): The sensitivity of the
[MIC GAIN]
microphone increases as the number increases.
[NR LEVEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
• Call quality may depend on mobile phone.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
To return to the previous setting item, press
[SETTINGS]
[AUTO ANSWER] [01 SEC] to [30 SEC]: Answers an incoming call automatically in the selected
[RING COLOR]
.
[RING ILLUMI]
Default: [XX]

Make a call

You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
2
3
.
To return to the previous setting item, press
time (in seconds). ; [OFF]: Cancels.
(For KD-T922BT/KD-X38MDBT)
[COLOR 01] to [COLOR 49] ([COLOR 08]): Selects the illumination color for
the buttons as notification when there is an incoming call and during a call. ;
[OFF]: Cancels.
(For KD-DB622BT)
[BLINK 01] to [BLINK 05] ([BLINK 02]): Selects the blinking pattern for the
buttons as notification when there is an incoming call. ; [OFF]: Cancels.
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
to the other phone.
"(Second device name)" appears.
Turn the volume knob to select an item (page 22), then press the
knob.
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
Default: [XX]
again to switch
.
ENGLISH 21