1. Introduction
SAVE THESE INSTRUCTIONS: This manual contains information for the proper
assembly, operation and care of your sprayer. Carefully read and follow the instruc-
tions contained in this manual before using your sprayer.
This equipment is designed to be used with the following products:
• Pest Control – Diclorvos-based inseticide, Cipermetrina and Fipronil.
• Disinfection - Disinfectants based on quaternary ammonia, sodium hypo-
chlorite, chlorine and ethyl alcohol.
• Agriculture - Herbicides, fungicides, insecticides, bioproducts and other
products intended for plant protection.
NOTE: This equipment is not recommended for the use with acids or alkaline
products.
The use of product in the equipment other than what is listed above may result in
damage to the equipment and loss of warranty.
2. Specifications
Model
Net weight
Gross weight
Spray lance length
Hose length
Chemical tank
Capacity
Filling opening diameter
Material
Pump
Type
Maximum working pressure
Nozzle installed
Material
SAFETY GUIDELINES – DEFINITIONS
It is important for you to read and understand this manual. The information it
contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The
symbols below are used to help you recognize this information.
DANGER!
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING!
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION!
Indicates a potentially hazardous situation which, if not avoided, may re-
sult in minor or moderate injury.
Notice: Used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
SAVE THESE INSTRUCTIONS: This manual contains important safety instruc-
tions for the proper use and maintenance of this product.
HD 400
3.7 kg
4.3 kg
600 mm
1650 mm
16 L
115 mm
Polyethylene
Piston
75 psi (5.1 bar)
Blue Adjustable Cone
Polypropylene
3. Preparing the Product For Use
3.1. Unpacking
Remove from the sprayer carton the following parts
Lever
Lance
Manual
Accessories
plastic bag
NOTE: Minimum space needed for use, maintenance and repair is 1,5 m².
WARNING!
Be careful when taking out the sprayer out of the carton
because the lever is loose and can cause damage or
personal injury. Note that the agitator is loose inside the
tank and must be properly assembly.
NOTE: Carton can be discarded in recyclable waste.
3.2. Installing the shaft
• Insert the shaft (1) in the free opening on the tank base (on the same side of
the chamber).Fit the shaft lock (2).
Shaft
(1
)
3.3. Installing the lever
• Lightly greases the orifice on the chamber top.
• Fit a flat washer on the shaft and rod.
• For easy assembly, install the lever on the shaft and the rod on the chamber
top at the same time.
• Install the other flat washers on the shaft and rod and lock with the lock ring.
Locked
ring
Flat
washers
Rod
Lever
Locked
ring
:
Haste
Tank
Hose
Trigger
valve
Shaft
lock(2)
Shaft
Flat
washers
3/36