Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
When cutting the workpiece which has the dimension of "*" there might be some possibility of
the lower end of the circular saw to touch with the workpiece, even if the motor head is located
at the lower limit position. Pay attention when cutting the workpiece. For further details, refer
to "PRACTICAL APPLICATIONS" on page 22. Mount the auxiliary board on the fence surface
(Refer ( ) the thickness of auxiliary board). Refer to "5. Cutting large workpieces" on page 25
(Fig. 27).
ACCESSORIES
WARNING:
Accessories for this power tool are mentioned in this Instruction
Manual.
The use of any other attachment or accessory can be dangerous and
could cause injury or mechanical damage.
STANDARD ACCESSORIES
1 12" (305 mm) TCT Saw blade
(1 piece) (For wood)
4 17 mm Wrench (1 piece)
OPTIONAL ACCESSORIES...sold separately
Crown molding Vise Ass'y (Code No. 339660) (Include Crown molding Stopper (L))
1
Crown molding Stopper (L) (Code No. 339730)
2
Crown molding Stopper (R) (Code No. 339731)
3
NOTE:
Accessories are subject to change without any obligation on the part of the
metabo HPT.
2 Dust bag (1 piece)
For how to use, refer to page 34.
5 Holder (1 piece)
For how to use, refer to page 12.
Fig. 3
English
3 Vise Assembly w/knob bolt
(1 piece)
For how to use, refer to page 23.
6 Sub table Assembly (2 piece)
For how to use, refer to page 19.
11
Publicidad
Tabla de contenido
